I've had my eye on those little "PSone" slim ps1s for quite a while now. I checked the board, I didn't see any bridged connections, could it be a resistor or capacitor that's going out? This is the first time I've taken apart this system, so I doubt I could have hurt anything, unless I hit it REALLY hard, which I haven't. Is that normal? Now the system will only start if I leave it unplugged for a few hours, only to freeze either in mid game, or even mid-boot. I have taken apart the PS1, and by the time I got to the motherboard, the CD-ROM controller was EXTREMELY WARM. (Not only that, but I suck at soldering TINY wires to even TINIER points.)
-1.jpg "burn playstation 1 games"){kind=avatar}
#BURN PLAYSTATION 1 GAMES INSTALL#
I'm not going to install a chip, not after my little "incident" with the XenoGC and my gamecube. I assume you have a mod chip installed.I do not have a mod chip installed, I'm using the swap trick to boot my burned games. Right-Click the name of the image in Alcohol 120 and select 'Image Burning Wizard' 5. Get the image you want to burn and open up Alcohol 120. But for this ones i cannot make a backup :(. Unless you have bumped something and you are now bridging connections inside. Playstation (duh) - Blank CD (duh) - Alcohol 120 (software) -1. Im trying and wasting so many cds to burn: Driver 1, Resident Evil 1,2,3, Biohazard 1, 2, 3 is a PS2 FAT model 39000, and is freezing in Playstation Logo.I already burned almost all ps1 games and it is working fine. I have had at least 20 or 30 ps1 systems come through here and never have I seen one that would not at least show the start up screen.
0 kommentar(er)
